Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DFI ES220F-CS
Summary of Contents for DFI ES220F-CS
- Page 1 Quick Installation Guide ES220F-CS Compact Fanless Embedded System www.dfi.com Package Contents • 1 ES220F-CS system unit with wallmount • Adapter 12V 60W (optional) • Power Cord 1830mm (optional) • VESA mounting kit (optional) © May 12, 2023 DFI Inc.
-
Page 2: Product Overview
Product Overview Front View - 1 storage Front View - 3 storage Power Button Status LED, Reset Button HDMI 2.0 USB 3.1 LAN 1 & LAN 2 Quick Reference | ES220F-CS... - Page 3 Rear View - 1 storage Rear View - 3 storage Grounding Hole COM 1 COM 2 USB 2.0 DC-in Quick Reference | ES220F-CS...
-
Page 4: Removing The Chassis Cover
Remove the screws and put them in a safe place for later use. And then tilt up the cover to remove it. Top View Bottom View Step 2: Lift the cover to open the system. Quick Reference | ES220F-CS... - Page 5 Step 3: The board can be easily accessed after the chassis cover is removed. Top View Bottom View Quick Reference | ES220F-CS...
-
Page 6: Installing An M.2 Card
The 2 screws on the bottom of the system are used to secure the cover to the chassis. Remove the screws and put them in a safe place for later use. Lift the cover to open the system. M.2 card slots can be easily accessed after the chassis cover is removed. M.2-M Quick Reference | ES220F-CS... - Page 7 Screw tight the card onto the stand-off with a screw driver and a stand-off screw until the gap between the card and the stand-off closes up. The card should be lying parallel to the board when it’s correctly mounted. Quick Reference | ES220F-CS...
-
Page 8: Installing An Antenna
There are antenna holes reserved on the front and back side of the system and covered by 4 knockout tabs. Please remove the knockout tabs prior to installing an antenna. Knockout tabs for Antenna Hole Knockout tabs for Antenna Hole Quick Reference | ES220F-CS... - Page 9 Connect the internal cable to the board's antenna connector, screw the antenna connector through the antenna hole with washers and nuts, and screw on the antenna as illustrated below. Antenna Chassis Wall Module Connector Cable Antenna Connector Washer Quick Reference | ES220F-CS...
- Page 10 Locate the mounting holes on the bottom of the system as shown in the photo. Screw on the two brackets onto the system with four screws as illustrated below. ES220F-CS 1 storage as an example: Wall Mount Bracket...
-
Page 11: Vesa Mount
If equipment installed on monitor by VESA mount, the weight for monitor should under 6.1kg ES220F-CS 1 storage as an example: VESA Mount Bracket DFI reserves the right to change the specifications at any time prior to the product's release. This QR may be based on the product’s revision. For more documentation and drivers, please visit the download page at www.dfi.com/...