Maintenance Of Eletrical Circuits, Equipment And Navigation Components; Adjusting Blade Deceleration - SNT SPIDER AUTONOMOUS 2.0 Operation Manual

12.12 MAINTENANCE OF ELETRICAL CIRCUITS,
100
EQUIPMENT AND NAVIGATION COMPONENTS
Keep all parts of electric circuits clean, especially from oil products, dust
sediments and dry grass. Replace conductors with damaged insulation. For
replacement use only original conductors supplied by the manufacturer.
Entrust repairs of electrical circuits only
to an authorized service.
The transmitter (radio remote control and correction
station) and receiver (receiver dome) have been
adjusted and set up by the manufacturer.
Do not interfere with these devices in any way.
They are programmed to each other.

12.13 ADJUSTING BLADE DECELERATION

The electromagnetic clutch is placed under the clutch cover [ A ] above the
rotary blades. The clutch was adjusted by the manufacturer. When engaged
the clutch transmits power onto the blades, when disengaged the brake stops
the rotating blades. Do not change the clutch setting. If damage on this part of
the machine should occur, always leave the repairing to an approved dealer.
The maximum rundown time of the rotary blade was set to 5 seconds.
After finishing any work on the electromagnetic clutch,
the cover must be returned to its original place and
properly sealed to prevent the clutch from getting dirty.
101
A