Machine Preparation And Engine Start-Up; Switching Off The Engine - SNT SPIDER AUTONOMOUS 2.0 Operation Manual

10.2 MACHINE PREPARATION AND ENGINE START-UP

64
Procedure:
1. Check the oil level, that there is sufficient fuel in the tank and that the tires
are inflated correctly (3.0 bar, 43 PSI).
2. Unlock the EMERGENCY STOP lock button on the top cover of the machine
body.
3. Check that both the battery light and the neutral light are green.
4. Switch on the remote control by turning/ pulling the main switch (EMER-
GENCY STOP) to the upper position. The POWER LED will light up.
5. Wait for Bluetooth connection of the machine to the RC.
The CONNECTED LED on the RC lights up.
At the same time, the LED light on the Bluetooth receiver dome of the
machine changes from green to blue.
6. The mower deck must be switched off during starting — make sure that
the mower deck control lever on the RC is in the off position. Otherwise,
starting will take place, but the mowing lever must be switched back to the
off position and then back to the on position to start mowing.
7. Switch the motor lever to the ON position.
8. Press the SOS/TEST button to verify its functionality. The machine must
flash the LED strips on the machine's perimeter red in response to pressing
the SOS/TEST button. This step is not required for Manual mode, but is a
prerequisite for Autonomous and Perimeter modes.
9. Hold the START button until the machine starts, but no longer than 3 seconds.
If necessary, repeat pressing the START button after a 20s delay (the motor
lever must be switched first to off and then back to on).
When starting, do not stand close to the mower
but keep a safe distance.

10.3 SWITCHING OFF THE ENGINE

Procedure:
1. Always switch off the mowing deck on the remote control before switching
off the engine [ 16 ].
2. Do not switch off the engine immediately after mowing, leave it running for
a while with the minimum speed to allow it to cool down.
3. Switch off the engine by switching the ignition switch [ 12 ] on the remote
control and then press POWER ON / STOP [ 21 ] on the remote control.
4. Press the EMERGENCY STOP button [ 1 ] on the mower and remove the key.
12
21
16
1
65