Engine Maintenance; Engine Oil Change - SNT SPIDER AUTONOMOUS 2.0 Operation Manual

12.3 ENGINE MAINTENANCE

92
The following activities are considered as workshop
maintenance and should only be carried out by
trained persons.
Before starting any maintenance work on the mower,
switch off the engine and allow it to cool down, press
the EMERGENCY STOP button [ 1 ] on the mower and
remove the key. Also switch off the RC using the switch
on the control panel.
To avoid the possibility of the engine starting unexpectedly, disconnect the
[ + ] clamp on the battery.
The engine should only be repaired by an authorized dealer/service center with
the appropriate tools, tools, spare parts and expertise.
[ + ] clamp 1

12.4 ENGINE OIL CHANGE

Observe the replacement interval according to the manufacturer's instructions
- see 12.2 Engine Maintenance Plan.
Drain the oil while it is warm but not hot.
Remove the side cover on the side of the fuel tank.
Remove the drain hose from the holder.
Unscrew the plug and place the hose in the prepared container and let the
oil flow freely the container
Screw the drain hose plug back in and clip the hose back into the holder.
Add the required amount of engine oil.
After starting the engine, check the oil level again and top up the oil if
necessary.
93