Bernina 735 User Manual page 161

Message on the Display
#1000
#1001
#1002
#1003
#1004
#1005
#1010
Cause
The calibration of the Buttonhole
Foot with Slide #3A has failed.
The needle threader is jammed.
The button «Thread Cutter» is
stuck or defective.
The button «Needle position Up/
Down» is stuck or defective.
The button «Start/Stop» is stuck
or defective.
The exact cause of the
malfunction cannot be
determined.
Solution
> Check the presser foot for ease of movement. If
necessary, remove lint, dust and fabric remnants.
> Clean the reflector with a soft, slightly damp microfiber
cloth.
> Check the position of the reflector. If necessary, correct
the position of the reflector or replace the presser foot.
> Check the plastic on the underside of the presser foot
for signs of wear. If necessary, replace the presser foot.
> Clean the feed dog.
> If the error still occurs, contact your authorized BERNINA
dealer.
> Switch off the machine. Press the needle threader down
and release it again. Switch the machine on.
> If the error still occurs, contact your authorized BERNINA
dealer.
> Make sure that the button can be operated without
restriction.
> If the error still occurs, contact your authorized BERNINA
dealer.
> Make sure that the button can be operated without
restriction.
> If the error still occurs, contact your authorized BERNINA
dealer.
> Make sure that the button can be operated without
restriction.
> If the error still occurs, contact your authorized BERNINA
dealer.
> Restart the machine.
> If the error still occurs, contact your authorized BERNINA
dealer.
Errors and Faults
161