Connection Of The Drain Hose - Omega ODD614X Instruction Manual

Connection Of The Drain Hose

There are two recommended options for connecting the drain hose.
Option A: Connecting to the sink waste
This is the typical modern method.
Check if your sink waste pipe has provision for this method.
Beware if it has the drain hose spigot that has never been used, it will likely be blanked
off inside the spigot.
This will need careful drilling/cutting out to make it operational. Ensure that the
opening you make has no ragged edges that will likely lead to debris snagging over
time and causing a blockage.
First cut off the head of the drain hose. When inserting the hoses into the Y piece,
wet the hose ends for ease of insertion. Insert fully. Use the hose support clip provided,
install as per the illustration. Insure that the hoses have a straight run from the clip to
the connection to the waste pipe.
Cut off the head of the drain hose
Drain hose
support cup
Cold water supply
with faucet
18
Drain hoses must not
loop downwards