Tension Adjustment Of The Door Spring; Connection Of Drain Hoses - Omega PL403A Instruction Manual

●

Tension adjustment of the door spring

The door springs are set at the factory to the proper tension for the outer door.
If aesthetic wooden panel are installed, you will have to adjust the door spring tension.
Rotate the adjusting screw to drive the adjustor to strain or relax the steel cable
(see figure 5).
Door spring tension is correct when
the door remains horizontal in the
fully opened position yet rises
to a close with the slight lift of a
finger.
●

Connection of drain hoses

Insert the drain h ose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to
avoid bending or crimping it. The top of the ho se must be less than 1000mm.
NOTE
The top of the hose
must be less than
1000mm.
，
【 】
Figure5
Tension adjustment
of the door spring
Front
Drain pipe
A
B
φ 40mm
Counter