Water Supply And Drain - Omega OSI700 Instruction Manual

Hide thumbs Also See for OSI700:
Table of Contents

Advertisement

Installation Instruction
Australian & New Zealand Product Warranty Statements of Standard Warranty Conditions
Australian Customers

Water Supply and Drain

Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement
or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to be of
Cold water connection
acceptable quality and the failure does not amount to a major
failure.
Connect the cold water supply hose to a threaded 3/4 inch connector
New Zealand Customers
and make sure that it is fastened tightly in place.
Nothing herein contained shall be construed in any way as
excluding or limiting your rights under the Consumer Guarantee
If the water pipes are new or have not been used for an extended period
Act 1993.
of time, let the water run to make sure that the water is clear. This
Our Warranty
precaution is needed to avoid the risk of the water inlet to be blocked
This product is also covered by the manufacturer's warranty set
and damage the appliance.
out in this document (Our Warranty).
Our Warranty is for a period of twenty four (24) months from the
date of purchase and for refrigeration appliances will have an
additional thirty six (36) months after the first twenty four (24)
months on the Sealed System (PARTS only) Compressor &
About the safety supply hose
condenser etc. The labour cost to replace these parts is the
responsibility of the customer. This is in addition to (and does
not exclude, restrict or modify) any rights or remedies to which
The safety supply hose consists of the double walls. The hose's system guarantees its intervention by
you may already be entitled under the Australian Consumer Law
blocking the flow of water in case of the supply hose breaking and when the air space between the supply
or the New Zealand Consumer Guarantee Act 1993 relating to
hose itself and the outer corrugated hose is full of water.
this product. Our Warranty (which is subject to the conditions
below) covers rectification free of charge of any fault arising from
defective materials or components, or faulty workmanship. The
product will be repaired or replaced at the option of Omega, and
WARNING
all costs of installation, removal, cartage, freight travelling
expenses and insurance are to be paid by the customer.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher.
Our Warranty is subject to the following conditions:
If your sink has one, it is recommended that the hose be disconnected and the hole plugged.
1.
That the purchaser contact Omega prior to any product
repair.
2.
That the purchaser carefully follows all instructions provided
with the product and complies with all relevant electrical &
How to connect the safety supply hose
plumbing regulations in their State when installing the
product.
1. Pull the safety supply hoses completely out from storage compartment located at rear of dishwasher.
3.
That the purchaser carefully follows the instructions
provided in the owner's handbook relating to the proper use
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4 inch.
and care of the product and does not use the product for
3. Turn water fully on before starting the dishwasher.
any purpose other than the DOMESTIC use for which it has
been designed. If the appliance is used in commercial
applications or for rental purposes, Our Warranty is limited
to a warranty of Twelve (12) months covering all parts with
Three (3) months on any labour cost of service or repair.
How to disconnect the safety supply hose
Service Area
1. Turn off the water.
The provision of service under Our Warranty is limited by the
boundary / territory area of the nearest service centre. Travelling
2. Unscrew the safety supply hose from the faucet.
cost incurred for service outside this area is not covered by Our
Warranty
Contact Us Australia
Omega is a division of Shriro Australia Pty Ltd
Phone: 1300 739 033
Email: customercare@omegaappliances.com.au
and service will incur commercial cost to be paid by the
customer regulated by the number of kilometres travelled
beyond the service area. These costs will be disclosed to you for
acceptance by you prior to your claim being processed.
Microwave ovens must be returned to your nearest Authorised
Service Centre for repair as they are a carry in serviceable
appliance.
What is Covered by our Warranty
During the warranty period, Omega or its authorised Service
Centre will, at no extra charge, if your appliance is readily
accessible without the need of special equipment and subject to
the terms and conditions of this warranty, repair or replace any
parts which it considers defective.
What is not Covered by our Warranty
1.
Products installed damaged or incomplete or not in
compliance with the relevant electrical & plumbing
regulations in their State.
2.
Normal wear and tear e.g. cleaning, light globes, filters etc.
3.
Failure resulting from power surges and electrical storms.
4.
Insect or vermin infestation.
5.
Unauthorised repairs or use of non-genuine Omega parts.
6.
Any failure caused by the product not being used in
accordance with the instruction and the installation manual
provided with the product.
7.
Misuse or abuse, including failure to properly maintain or
service.
8.
The clearing of blockages in pumps and hoses.
9.
Damage which occurs during delivery or installation.
10. Claims to product surface coating due to liquid or solid
spill-overs, accidental damage or damage caused from
cleaning products not recommended by Omega.
How to Claim Our Warranty
While registering your warranty is not a requirement, for peace
of mind you can register your warranty at
omegaappliances.com.au.
To make a claim under Warranty you will need to contact
Omega in Australia or New Zealand by using the contact details
below.
If you are contacting Omega regarding any warranty claims and
spare parts inquiries, please make sure you have the following
information on hand:
1. Product Name/Model Number
2. Serial Number/s
3. Purchase Date (as per invoice or proof of purchase)
4. Purchased From
5. Warranty Registration Number (if registered)
Contact Us New Zealand
Omega is a division of Monaco Corporation (member of Shriro)
Phone: 09 415 6000
Email: customercare@monacocorp.co.nz
7
22
7
safety supply hose

Advertisement

Table of Contents
loading

Table of Contents