Table of Contents
Advertisement
Turn the CO
bottle regulator OFF (Anti-clockwise). The knob will screw up
1.
2
and away from the bottle.
Remove the bottle from the cupboard and disconnect the regulator. If the
2.
braided hose is removed from the regulator, be careful not to loose the
small plastic sealing olive, located inside the end of the hose.
Fit the regulator and hose assembly to the new gas bottle. Be aware that
3.
some CO
may be discharged from the bottle joint. Any CO
2
be cold.
Fit the bottle in an upright position (use the velcro securing strap).
4.
Turn the regulator ON (Clockwise) and adjust to 2.7-3.0 bar. (Green zone
5.
on dial).
Check all joints for gas leaks using a sponge and soapy water.
6.
Press the [MENU] button for main
7.
menu.
Press the [Install] button.
8.
Press the [Purge CO
9.
In the next screen, press the
10.
[START] button to commence the
purging process.
Wait for the water to stop flowing
11.
through the unit. Then wait a few
seconds more, until you hear only
CO
gas escaping through the tap.
2
Press [STOP] to end the purge
12.
Press [<=] button for the previous
13.
menu or press the [Home] button to
return to the home screen.
The display screen should revert to Normal operation.
14.
Dispense some sparkling water from the tap and perform a taste test.
15.
The 1.0 kg gas bottle supplied with this appliance is a disposable
Note:
item and cannot be refilled. Please contact your local city council for collection
centre details or return the bottle to your service agent for recycling.
General cleaning
Do not use strong, corrosive, spray or abrasive cleaners. Clean with a soft
damp cloth and mild soap.
Under sink units must never be located near, or cleaned with water jets.
Avoid using airborne pesticides near the undersink unit.
802006NZ - HT-BCS;BCSH A-AV User Manual - May 2016- v3.00
Gas bottle change
] button.
2
Cleaning
released will
2
Page 29 of 32
Advertisement
Table of Contents
