Zenith 802006NZ User Manual page 16

LCD Screen operation - Section C
ON
OPEN
Position
CLOSED
OFF
Position
The Zenith HydroTap allows the user to adjust the filter life and to edit the
filter usage. (See filter details on Page 22 ).
2. - Filter Reset
After replacing the filter, the counters should be reset
3. - Boiling Calibration
During calibration, boiling water units may vent steam from the
Caution:
tap spout. Take care to avoid personal injury whenever this occurs.
On start up, the hydroTap starts a self-calibrating program. The controls
take the system through the calibration process. Once complete, the system
reverts back to normal operation. If you would like to calibrate the system
anytime after installed, please follow the steps below.
Page 16 of 32
Press the [MENU] button for main
1.
menu.
Press the [Install] button.
2.
Press the [Filter Reset] button.
3.
To set the filter life or edit filter usage,
4.
refer to section G- Filter.
1. Press the [MENU] button for main
menu.
2. Press the [Install] button.
3. Press the [Hot Calibration] button.
4. In the next screen, press [Calibrate] if
you want to start calibration.
802006NZ - HT-BCS; BCSH A-AV User Manual - May 2016 - v3.00