Zenith 802006NZ User Manual page 17

LCD Screen operation - Section C
4. - Booster
This function should only be considered when a Booster unit is installed.
Failing to make the correct selection for 'Booster' will effect product
Note:
performance.
5. - CO Purge
2
When fitting a new gas bottle, it is important to purge the gas lines.
6. - Lux Sensor Calibration
the room is darkened (below the calibrated light level), the tap lights will
turn OFF after aprox 30 seconds.
802006NZ - HT-BCS;BCSH A-AV User Manual - May 2016- v3.00
1. Press the [MENU] button for main
menu.
2. Press the [Install] button.
3. Press the [Booster] button.
4. If a Booster is installed, select YES to
enable the Booster.
5. Dispense boiling water for 30 secs
and check the outlet hose from the
Booster is warm.
6. If no Booster is installed, select NO.
Press the [MENU] button for main
1.
menu.
Press the [Install] button.
2.
Press the [Purge CO
3.
In the next screen, press the
4.
[START] button to commence the
purging process.
Wait for the water to stop flowing
5.
through the unit.
Wait a further 10 seconds after the
6.
water has stopped flowing. During
this time you will hear the CO
escaping through the tap.
Press [STOP] to end the purge.
7.
Press [<=] button for the previous
8.
menu or press the [Home] button to
return to the home screen.
1. Press [MENU] for main menu.
2. Press [Install] .
3. Press [Lux Sensor Calibration]
4. The lights on the Tap head will flash
to confirm calibration.
5. Check for correct tap operation by
selecting 'Lux Sensor-> OFF'. When
] button.
2
gas
2
Page 17 of 32