Table of Contents
Advertisement
3.
LCD Screen operation - Section G
Energy Modes
This mode allows the HydroTap to enter into Energy Saving mode. There are
two options available: 'Sleep' mode and 'ON/OFF' mode.
In Sleep Mode the unit will go to "Sleep" after a 2hr period of inactivity.
The Boiling water will gradually drop to either 68°C or room temp, as shown
in the table below and the Chilled water will be ON or OFF.
When the period of inactivity passes, the home screen status window will
show "Sleep Mode".
Sleep Mode
2 Hours-> 68°C
2 Hours-> OFF
Lux Sensor->68°C
Lux Sensor-> OFF
Lux or 2 Hr-> 68°C
Lux or 2 Hr-> OFF
Disable
Lux (Light) Sensor Calibration: (Not for Elite tap)
It is recommended to recalibrate the Lux (Light) Sensor after selecting any of
the 4 Lux sensor options from the sleep mode menu. Before commencing,
ensure there are 'Normal to Dim' (Not Dark) operating light conditions.
Note: Refer to section C6 on Page 16 for calibration procedure
802006NZ - HT-BCS;BCSH A-AV User Manual - May 2016- v3.00
To activate the sleep mode:
1. Press [MENU] button for main
menu.
2. Press [Setting] button.
3. Press [Energy Modes] button.
4. Press [Sleep Modes] button then in
the next screen, use the up and down
arrows to select one of the 7 options, as
shown in the table below.
Light
Time
State Boiler Chiller
Level
Delay
N/A
2 Hr
Sleep
N/A
2 Hr
OFF
Dark
N/A
Sleep
Dark
N/A
OFF
Dark
2 Hr
Sleep
Dark
2 Hr
OFF
N/A
N/A
ON
68°C
ON
OFF
OFF
68°C
ON
OFF
OFF
68°C
ON
OFF
OFF
ON
ON
Page 23 of 32
Advertisement
Table of Contents
