Table of Contents
Advertisement
Safety Sensor Calibration (lever models)
Light intensity varies from site to site, therefore it is recommended that a
re-calibration be performed at the time of the installation.
All direct natural sun light must be shaded from the HydroTap, during the
calibration. This can be achieved by closing any nearby curtains, blinds, etc.
or by shading the tap with a dark cloth.
With the unit in Normal operating mode
1.
and with the safety enabled
Turn the power OFF
2.
Pull both tap levers to the forward
3.
position
Turn ON the power
4.
The unit will calibrate the safety switch
5.
Return the levers to the neutral
6.
position.
To check the calibration, dispense Boiling water, in normal light
7.
conditions with the safety enabled.
802006NZ - HT-BCS;BCSH A-AV User Manual - May 2016- v3.00
Pull both levers forward
Safety
sensor
Page 11 of 32
Advertisement
Table of Contents
