Electrorad Digi-Line Installation/Operating page 3

Electrorad Digi-Line
04
1.0 Warnings & Safety Information
CAUTION
Some parts of this
product can become very
hot and cause burns.
Particular attention has to
be given where children
and vulnerable people
are present.
In order to avoid
overheating, do
not cover the radiator.
"Do not cover" means
that the radiator must
not be used for drying
clothes, for example,
by placing them directly
on the radiator.
IMPORTANT SAFETY
INSTRUCTIONS!
Before starting work disconnect power supply!
All installation work and wiring work related
to the radiators, thermostats and programmers
must be carried out only when de-energised.
The appliance should be commissioned by
qualified professionals only.
(cont...)
Make sure to adhere to valid safety regulations.
Any repairs or maintenance within the warranty
period should be carried out only by approved
service engineers confirmed by Electrorad UK
Ltd.
For the correct installation of radiators it
is essential that the fixing of the radiator is
carried out in such a way that it is suitable
for intended use AND predictable misuse. A
number of elements need to be taken into
consideration including the fixing method
used to secure the radiator to the wall, the
type and condition of the wall itself, and
any additional potential forces or weights,
prior to finalising installation. IN ALL CASES
IT IS STRONGLY RECOMMENDED THAT
A SUITABLY QUALIFIED PROFESSIONAL
INSTALLER OR SIMILAR TRADESPERSON
CARRIES OUT THE INSTALLATION.
PLEASE NOTE: The fixing materials provided
are only intended for installation on walls made
of solid wood, bricks, concrete or on timber-frame
stud walls where the fixing is into the timber. All
walls being considered should have no more than
a maximum of 3mm wall finishing. For walls made
of other materials, for example hollow bricks,
please consult your installer and/or specialist
s upplier. ONCE AGAIN, IF YOU ARE UNSURE,
IT IS STRONGLY RECOMMENDED THAT
A SUITABLY QUALIFIED PROFESSIONAL
INSTALLER OR SIMILAR TRADESPERSON
CARRIES OUT THE INSTALLATION.
The radiator is equipped with an overheat
protection that cannot be reset (melt fuse).
This overheat protection disconnects the
current if the radiator becomes too hot (e.g.
when covered).
If the supply cord is damaged, it must be
replaced by the manufacturer, his service
agent or similar qualified persons in order to
avoid a hazard.
1.0 Warnings & Safety Information
The radiator is filled with an exact amount
of environmental friendly vegetable oil. Any
repairs that require the radiator to be opened
shall therefore only be carried out by the
2.0 General Information
The appliance is a sealed electric radiator
l
designed for fixed wall mounted installation.
The radiator conforms to the standards
l
EN 60335-1 and EN 60335-2-30.
The radiator is class 1 and splash resistant
l
(IP44).
Electrorad Digi-Line
(cont...)
manufacturer or his approved agent. Please
contact Electrorad UK Ltd in case of leakage.
The radiator complies with the European
l
Directive 2014/30/EU (CE Marking on all
radiators).
The radiator is supplied complete with
l
power cable* and wall brackets.
Cable Hook Assembly
Back of Radiator
1. Thermostat Control
2. Power On/Off Switch
05