Troubleshooting & Solution; Preset Programmes - Electrorad Digi-Line Installation/Operating

Electrorad Digi-Line
20
11.0 Troubleshooting & Solution
Q: My Thermostat doesn't work.
A: Check the power supply.
l
Contact your installer.
l
Q: My Thermostat shows an Error message "
A: The symbol " + " flashes.
Error detected on the internal sensor.
Contact your installer or seller.
l
Q: My Thermostat seems to work correctly but the heating doesn't work correctly.
A: Is the radiator that is not heating up near an open window?
l
Check the settings in Parameter 06 (on page 14).
Contact your installer.
l
Q: My Thermostat seems to work correctly but the temperature in the room
is not in accordance with the programme.
A: Check the Clock.
l
The difference between Comfort & Reduced temperature is too high.
l
Proceed with a calibration of internal probe (see parameter 03 on page 13).
l
Q: The front heating panel is cooler than the back panel.
Check the power settings as indicated in section 4 (on page 13).
A:
l
Are these Q & A's to be kept?
To be discussed with Electrorad
at Proof 1
" blinks on the display.

12.0 Preset Programmes

d1
d3
d5
d7
d9
Electrorad Digi-Line
21
d2
d4
d6
d8
=
=