Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual page 31

Installation, Operation and Maintenance Manual
VCIOM-15081-EN Rev. 7
NOTE:
1. Safety Behavior:
It's an enumerated register, the possible values are:
Values
0
1
2
3
4
2. Next Maintenance Date, Last Maintenance Date, Start Up Date, Test Date,
Recent LogDate, Date of last torque profile in OP, Date of last torque profile in CL,
Date of torque reference in OP, Date of torque reference in CL:
These registers contain date data that are represented in BCD format. The first register contains the
day (in the first byte) and the month (in the second byte); the second register contains the year.
Example: Next Maintenance Date (H. Registers 13, 14 - Address 12, 13)
3. Channel Mode:
It's an enumerated register, the possible values are:
Values
0
1
2
4. Actuator Status 1:
This is a bit enumerated register. The possible values are:
Values
b0
b1
b2
b3
b4
b5
b6
b7
b8
b9
b10
b11
b12
b13
b14
b15
Modbus I/O List
Description
Off
Close Command
Open Command
Stay Put
Go to xx%
Holding Register 12 = 0x1511
Holding Register 13 = 0x2008
Description
Channel1 Enabled, Channel2 Disabled
Channel2 Enabled, Channel1 Disabled
Auto: Channel1 Enabled, Channel2 Enabled
Description
1 = Close Limit
1 = Open Limit
1 = Actuator Moving
1 = Monitor Relay
1 = Selector in LOCAL
1 = Selector in REMOTE
1 = Alarm
1 = Warning
1 = DIN1
1 = DIN2
1 = DIN3
1 = DIN4
1 = DIN5
1 = DIN6
1 = Interlock Open
1 = Interlock Close
Section 7: Modbus I/O List
Day: 15, Month: 11 (November)

Year: 2008

October 2022
27