Emerson Bettis XTE3000 Installation, Operation And Maintenance Manual page 22

Section 7: Modbus I/O List
October 2022
9. Warning Log:
These registers contain several types of data: the first register is an enumerated register and contains
the warning code; the second and the third registers contain the date of the warning; the forth and
the fifth registers contain the time of the warning.
Date and time are represented in BCD format, see Notes 6 and 7 for details.
Registers from address 65 to 69 contain data of the most recent warning; registers from address
70 to 74 contain data of the second recent warning; registers from address 75 to 79 contain data of
the third recent warning; registers from address 80 to 84 contain data of the forth recent warning;
registers from address 85 to 89 contain data if the fifth recent warning.
The table below shows the possible values of the warning code:
Values
b0
b1
b2
b3
b4
b5
b6
b7
b8
b9
b10
b11
b12
b13
b14
b15
10. Nominal Torque/Thrust:
These registers contain two type of data. The first register (address 95) contains the torque/thrust
engineering unit in the first byte and an ASCII character in the second byte.
Other registers contain ASCII character, one character for each byte.
The table below shows the engineering unit codes:
Values
0
1
2
3
18
Installation, Operation and Maintenance Manual
Description
1 = Hi-Hi Torque in open direction
1 = Hi-Hi Torque in close direction
1 = Hi-Hi Temperature
1 = Main Voltage
1 = Contactor Cycles
1 = Maintenance Request
1 = Motor Current
1 = Wrong Stroke Limit
1 = PST Error - Max. T1
1 = PST Error - Max. T2
1 = PST Error - Over Travel
1 = PST Error - PST Failed
Spare - Not Used
Spare - Not Used
Spare - Not Used
1 = General Warning
Description
lbf
Nm
lb
KN
VCIOM-15081-EN Rev. 7
Modbus I/O List