Before Locating The Fixing Brackets; Adjusting The Bracket Position - Caple C863I Instruction Manual

Table of Contents

Under all circumstances, make sure the induction hob is well ventilated and the air inlet and outlets

are not blocked. Ensure the induction hob is in good working state. As shown below

Note: The safety distance between the hotplate and the cupboard above the hotplate should be at

least 760mm.

A(mm)

B(mm)

C(mm)

760

50 mini

20 mini

Before you install the hob, make sure that

• the work surface is square and level, and no structural members interfere with space requirements

• the work surface is made of a heat-resistant material

• if the hob is installed above an oven, the oven has a built-in cooling fan

• the installation will comply with all clearance requirements and applicable standards and regulations

• a suitable isolating switch providing full disconnection from the mains power supply is incorporated in the

permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.

The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all

poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the

requirements)

• the isolating switch will be easily accessible to the customer with the hob installed

• you consult local building authorities and by-laws if in doubt regarding installation

• you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding

the hob.

When you have installed the hob, make sure that

• the power supply cable is not accessible through cupboard doors or drawers

• there is adequate flow of fresh air from outside the cabinetry to the base of the hob

• if the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed below the

base of the hob

• the isolating switch is easily accessible by the customer

Before locating the fixing brackets

The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto the

controls protruding from the hob.

Fix the hob on the work surface by screw 2 brackets on the bottom of hob(see picture) after installation.

Air intake

Air exit 5mm

Table of Contents