A/C Trough - ADVANCED UV LIGHT ELIXIR Owner's Manual

DANGER
RISK OF ELECTRIC SHOCK
The electrical connection must
be performed by a skilled
person, qualified according
to all applicable national/
local electrical standards and
regulations, i. e. EN 60201-
1/VDE 0113 or corresponding
standards.
 Connect the phases of the electric cable to the terminals.
 Mount the front sheet of the ballast tray with the handles
in front to the ballast tray.

Fasten the front sheet with four screws.

Push the brush seals onto the side plates and the back
plate of the ballast tray.
 Unloosen the screw on the sunbed plexi.

Open the top.

Lift the sunbed plexi and hold tight.
ORIGINAL DR. MÜLLER HIGH PERFORMANCE TANNING EQUIPMENT
19
 Tilt the sunbed plexi support slightly to the left and tilt
upwards.

When the support is in vertical position, let it down until it
locks.
 Let the plexi rest on the support to prevent the plexi from
falling down.
 Two (2) persons lift the ballast tray by a few centimeters in
the front and then push it under the sunbed.

A/C trough


Unpack the A/C trough.

Push the A/C trough under the sunbed..
Original Dr. Müller ®