Front Cover Plate; Removal Of Protective Foils; Body Cooling Fan - ADVANCED UV LIGHT ELIXIR Owner's Manual

Front Cover Plate


Hang the front cover plate with the hooks into the
sunbed.
 Fasten both quick connection to fix the front cover plate.

Removal of protective foils

 Slightly lift the sunbed plexi.

Slightly lift the plexi support and tilt it to the left.

Two (2) people hold the sunbed plexi.

Slightly lower the sunbed plexi.

Pull the sunbed plexi carefully out of its holding groove.

Remove the foil from the sunbed plexi.

Push the sunbed plexi back into its holding groove. Take
care that the notches in the sunbed plexi match with the
guide nibs. This is the only correct position for the sunbed
plexi.

Let the sunbed plexi down and secure plexi with the two
screws.
 Remove the protective foil from the top, the top plexi and
the front cover plate.
ORIGINAL DR. MÜLLER HIGH PERFORMANCE TANNING EQUIPMENT
21

Body Cooling Fan

 Unpack the body cooling fan.
 Remove the protective foil.
 Mount the body cooling fan in such a way to the body
cooling support plate that the air vents show towards the
sunbed bench.

Move the body cooling fan slightly forward until it locks.

Fasten the body cooling fan with the thumb screw to the
body cooling fan support.
Original Dr. Müller ®