Added Support For Cursor Operation Outside The Project Window (Nuage Master) - Yamaha NUAGE FADER Ncs500-FD Operation Manual

Added support for cursor operation outside the Project Window
(Nuage Master)
The operation target window when []/[]/[]/[] buttons are pressed can be selected from the Project Window or the
window displayed in the foreground.
Operation
Numbers in the illustration below correspond to the instruction
steps.
1.
Press [SETUP] in the MULTI FUNCTION
DISPLAY section.
2.
In the [Multi function display], touch the
"PAGE 3" tab.
3.
Select the target of cursor operation using the
[Multi function knob] that corresponds to "PC
KBD Emu Mode."
Off Targets the "Project Window" for operation.
On Targets the window displayed in the
foreground for operation.
4.
Operate the cursor using the []/[]/[]/[]
buttons on the GENERAL CONTROL section.
2 1
3
4
Added functions in NUAGE V2.0 45