Master Block - Yamaha MG Series Owner's Manual

Controls and Connectors

Master Block

q
w
MG16XU
i
MG20XU
r
24
MG20XU/MG20/MG16XU/MG16X/MG16/MG12XU/MG12X/MG12 Owner's Manual
e r
u
Rear Panel
e w q
q [SEND] jacks
MG20XU/MG20/MG16XU/MG16X/MG16: [AUX1 – 4]
MG12XU/MG12X/MG12: [AUX1 – 2]
t
You use these jacks, for example, to connect to an external
effect device or a stage/studio monitoring system. These are
impedance-balanced* phone-type output jacks.
* Impedance-balanced
Since the hot and cold terminals of impedance-balanced
output jacks have the same impedance, these output jacks
are less affected by induced noise.
w [GROUP OUT] jacks
y
These impedance-balanced TRS phone jacks output the
[GROUP 1-2 and 3-4] (MG20XU/MG20/MG16XU/MG16X/
MG16) signals. Use these jacks to connect to the inputs of a
multi-track recorder, external mixer, or another similar
device.
e [MONITOR OUT] jacks
Connect these impedance-balanced TRS phone jacks to your
operator monitoring system.
NOTE
When the [PFL] indicator is flashing, the signal for channels
where the [PFL] switch is pressed is output.
When the [PFL] indicator is off, the signal for the buses
selected in the [MONITOR] section y is output.
o