Yamaha NUAGE FADER Ncs500-FD Operation Manual page 84

Operation Function
HA +48V Turns +48 V phantom power on and off. To
turn on phantom power, hold down the
[Multi function button A] for longer than two
seconds.
To use this function, make sure to perform the following:
• Hardware connections
• Setting up the serial port
• Setting up the Nuage I/O
Hardware connections
Nuage I/O
AES/EBU
AD8HR
Connect the AD8HR and Nuage I/O by AES/EBU, and
connect the AD8HR and a computer by the RS-232C
(cross cable).
Use a USB to Serial converter if there is no serial port in
your computer.
Setting up the serial port
Make the following serial port settings on your computer:
Parameter
Bits per second:
Data bits:
Parity:
Stop bits:
Flow control:
Instructions for making serial port settings are depend on
your particular computer (in Windows 7, for example,
right-click an applicable serial port on the "Device
Manager" to open the properties). Refer to the manual of
your computer for details.
Computer
RS-232C
Value
38400
8
None
1
None
Setting up the Nuage I/O
Open the "Nuage I/O Properties" from the NUAGE
Workgroup Manager, and then set the "ID" number of the
AD8HR.
The AD8HR can also be set up in NUAGE HA Remote
Setup. To open NUAGE HA Remote Setup, click the
Nuendo menu "Devices"  "NUAGE HA Remote Setup."
Added functions in NUAGE V1.1 84