Oracle X5-2 Installation Manual page 41

Oracle solaris operating system

Hide thumbs Also See for X5-2:

Table of Contents

For example, do one of the following:

From the local server, press the Power button (approximately 1 second) on the front panel

■

of the server to turn the server off, then press the Power button again to power on the server.

From the Oracle ILOM web interface, click Host Management → Power Control, select

■

Reset from the Select Action list box, then click Save.

From the Oracle ILOM CLI, type:

■

The system begins the boot process and the BIOS screen appears.

Note -

The next event occurs very quickly; therefore, focused attention is needed for the

following steps. Please watch carefully for these messages as they appear on the screen for a

brief time. You might want to enlarge the size of your screen to eliminate scroll bars

To verify that PXE boot is enabled, perform the following steps:

PXE boot is enabled by default; however, this step directs you to verify that PXE boot is

Note -

enabled in the event that it was disabled. Once you have verified that PXE boot is enabled, you

can omit this step on subsequent PXE boots.

Press the F2 key to access the BIOS Setup Utility.

The BIOS Setup Utility appears.

Select Advanced in the top menu bar.

Install Oracle Solaris 11.2 (With SRU5 or Later) Using PXE Network Boot

reset /System

Installing the Oracle Solaris Operating System

Table of Contents