Oracle X5-2 Installation Manual page 103
Linux operating systems
Hide thumbs
Also See for X5-2:
- Service manual (274 pages) ,
- Installation manual (180 pages) ,
- Safety and compliance manual (62 pages)
Table of Contents
Advertisement
The server begins the boot process and the BIOS screen appears.
The next event occurs very quickly; therefore, focused attention is needed for the
Note -
following steps. Watch carefully for these messages as they appear on the screen for a brief
time. You might want to enlarge the size of your screen to eliminate scroll bars.
3.
In the BIOS screen, press the F8 key to specify a temporary boot device.
The Please Select Boot Device menu appears listing the available boot device.
4.
In the Please Select Boot Device menu, select the PXE install boot device
(physical network port) that is configured to communicate with your PXE
network install server, then press Enter.
The network bootloader loads and a boot prompt appears. After a few seconds, the installation
kernel will begin to load.
The initial SUSE Linux boot screen appears.
5.
To continue the installation, proceed to the following instructions:
For SLES 11 SP3,
■
Media" on page 77
For SLES 12,
Step 5
■
Media" on page 88
Step 5
in
"Install SLES 11 SP3 OS Manually Using Local or Remote
in
"Install SLES 12 OS Manually Using Local or Remote
Install SLES OS Using PXE Network Boot
Installing a Linux Operating System
103
Advertisement
Table of Contents
