Rikon Power Tools 11-600S Operator's Manual page 8

BLADE GUARD ASSEMBLY
WARNING: DISCONNECT MACHINE FROM POWER
SOURCE BEFORE CONTINUING STEPS BELOW.
• Install the table insert over the riving knife. Lock the
table insert in place by turning the lock knob
clockwise.
• Locate the anti-kick pawl and position onto the
mounting slot on the riving knife. Push down the
anti-kick pawlassembly until it locks into place as
shown (FIG. 13).
Figure 13
• Locate the blade guard and position onto the
mounting slots of the riving knife.
• Tighten the blade guard knob (A-FIG. 14) to lock the
guard assembly onto the riving knife.
Figure 14
A
WARNING: Make sure the blade guard assembly is locked
in place securely after installation.
(Continued from page 7)
PORTABLE STAND ASSEMBLY
Use the tools supplied for the stand assembly:
A. Flat Wrench
B. Hex Wrench
Figure 15
D
E
F
H
STEP 1: Insert the storage foot to the end of the stand.
Locate and install screws (C x2) to secure as shown in FIG.
16.
STEP 2: Attach screws (D x4) and nuts (E x4) to the handle
as shown in FIG. 16 and secure to the stand.
STEP 3: Attach nuts (F x2), and washers (G x2) and wheels
(H x2) to the stand axle as shown in FIG. 16.
Figure 16
C
8
C
A
G
B
Storage Foot
C
F
G
H
E Handle
D