Table of Contents
Advertisement
REAR TABLE EXTENSION ASSEMBLY CONT.
• Lay the saw upside down. Protect the table top with
cardboard from the carton.
• Loosen the two locking knobs as shown (FIG. 8) and
insert the rails into the rear of the saw.
Figure 8
• Slide the table extension inward into the base of the
saw until it stops.
• Locate two cotter pins from the hardware bag and
install as shown (FIG. 9.).
Figure 9
BLADE GUARD ASSEMBLY
WARNING: DISCONNECT MACHINE FROM POWER
SOURCE BEFORE CONTINUING STEPS BELOW.
• Remove the table insert by turning the lock knob
counter clockwise and lift out of the table (FIG. 10).
Figure 10
• Turn the elevation hand wheel (A-FIG. 11) to raise the
saw blade to its maximum height as shown.
• Lift up locking lever (B-FIG. 11) and insert the riving
knife. Lower the locking lever to securely clamp the
riving knife in position. Check position and clearance
in next step (Fig. 12).
Figure 11
A
Figure 12
RIVING KNIFE POSITION AND ADJUSTMENTS
CONTINUED ON PAGE 8
7
B
Top Distance
Minimum distance of 1/8" (3mm)
Maximum distance of 5/16" (8mm)
Bottom Distance
Advertisement
Table of Contents
