Table of Contents
Advertisement
THINK SAFETY
Safety is a combination of operator common sense and alertness at all times when the saw is being used.
Never use another person as a substitute for a table extension, or as additional support for a workpiece that is longer or
wider than basic saw table, or to assist in feeding, supporting or pulling the workpiece.
Do not pull the workpiece through the saw blade—position your body at the infeed side of the guard; start and complete
the cut from that same side. This will require added table support for long or wide workpieces that extend beyond the
length or width of the saw table.
CAUTION: Follow safety instructions that appear on the front of your saw.
UNPACKING
CAUTION: The package exceeds 100 lbs.Two-person lift is
required to prevent muscle strain or back injury.
Refer to Figure 2.
• Lay shipping box on its side. Open box and remove all parts
from both styrofoam packing bases and set Rolling Stand
Assembly (N)safely aside.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
Check for shipping damage or missing parts. If any parts are
damaged or missing, call 1-877-884-5167 for replacements.
The table saw body comes assembled as one unit. Additional
parts which need to be fastened to the saw should be located
and accounted for before assembling:
A. Table Saw Unit
B. Table Insert
C. Riving Knife
D. Wrench
E. Rail Assembly
F. Lock Knob
G. Blade Guard & Spreader Assembly
H. Miter Gauge
I. Rear Extension Wing
J. Rods for Rear Table Extension
K. Push Stick
L. Bagged Hardware
M. Manual
N. Rolling Stand Assembly
Figure 2 - Unpacking
5
Advertisement
Table of Contents
