Table of Contents
Advertisement
Connecting LP Gas Tank to LP Grill
1.Remove the screw on tank bolt & take off the
washer. Insert the tank bolt from rear of the grill and
reinstall the washer & screw set. From Rear of the
cart, place foot ring of 20 lb tank into the hole in
bottom panel. Make sure the tank valve is in OFF
position. Use the tank bolt to secure the tank in a
fixed position (Fig.20).
2. Check the tank valve to ensure it has proper
external mating threads to fit the hose and regulator
assembly provided.
3. Make sure all burner valves are in OFF position.
4. Inspect the valve connection port and regulator
assembly. Look for damage or debris. Remove any
debris. Inspect hose for damage. Never use
damaged or plugged equipment.
5. When connecting regulator and hose assembly to
tank valve hand tighten quick coupling nut clockwise
to a full stop (Fig.21) Do not use a wrench to tighten
because it could damage the quick coupling nut and
result in a hazardous condition.
6. Open tank valve fully (counterclockwise). Use a
soapy water solution to check all connections for
leaks before attempting to light your grill. If a leak is
found, turn tank valve off and do not use your grill
until the leak is repaired.
CAUTION: When the appliance is not in use, gas
must be turned off at the supply tank.
Figure 20
Figure 21
Regulator Connection
Your gas grill is now ready for use. Before the
first use and at the beginning of each season
(and whenever the LP gas tank has been
changed):
1. Read all safety, lighting and operating
instructions.
2. Check gas valve orifices, burner tubes and
burner ports for any obstructions.
3. Perform gas leak check according to
instructions found on next page of the manual.
12
Congratulations
Advertisement
Table of Contents
