Table of Contents
Advertisement
Installing Side Burner Shelf & Side Shelf
1. Remove (2) preinstalled 1/4 x 15mm Phillips head
screws from left side of grill head as shown. Do not
remove screws in fully; leave ¼ extended for shelf
assembly. (Fig. 10)
2. Through side burner shelf screw holes, hang side
burner shelf on two screws. (Fig. 11)
3. Using (2) 1/4 x 15mm screws with (2) 1/4 lock
washers & (2) flat washers from firebox inside to
securely attach side burner shelf to firebox. (Fig. 12)
4. Attach right side burner control panel to the main
control panel use (2) 5/32 x 10mm Phillips head screw
and (2) 1/4-in lock washer &(2) flat washer. (Fig. 12)
5. Repeat steps 2 through 4 to install left side shelf.
Installing Side Burner & Side Burner Valve
1. Remove the two 4mm screws with locking washers that
are pre-attached to the valve. Then place the Bezel on the
Side Burner Shelf control panel. From underneath, insert
the side burner valve into the Side Burner Shelf control
panel and Bezel. Align the holes in the Bezel with holes in
the valve and attach with two 4mm screws. The two
screws hold the bezel, control panel, and valve together.
As shown in Fig. 13A.
2. Open side burner lid and place the Side Tube Burner
through the opening. Place the Side Tube Burner tube
over the side burner gas valve and make sure Side Burner
gas valve is inserted into side burner tube. Then with two
5/32-in. x 10mm
Phillips
Locking Washers secure the side burner from underneath
to the Side Burner Shelf. As shown in Fig.13B.
3. Insert Side Burner Control Knob onto the valve stem
and tighten it by using the Allen Key. As shown in Fig.14.
4. Plug ignition wire into igniter wire electrode on
underside of burner. (Fig.15)
Figure 10
Figure 11
Head Screws and two 5/32-in.
3 00
4 0 0
50 0
6 00
2 00
1 0 0
7 0 0
8 00
3 00
4 0 0
5 00
2 0 0
6 00
1 00
8 00
70 0
Figure 12
4pcs: 1/4 X 15mm
Figure 13
A
B
Figure 14
Figure 15
10
4pcs: 5/32 X 10mm
Advertisement
Table of Contents
