Special Use Set-Up; Hst Upper Taping Head - Compression Spring - 3M AccuGlide HST Upper Instructions And Parts List

Special Use Set-Up Instructions
HST 3-Inch Upper Taping Head - Compression Spring
Refer to Figure 3-1
WARNING – UPPER TAPING HEAD UTILIZES AN EXTREMELY SHARP KNIFE BLADE LOCATED
UNDER THE ORANGE BLADE GUARD WHICH HAS THE "WARNING – SHARP KNIFE" LABEL.
USE CARE WHEN WORKING NEAR BLADE. IF CARE IS NOT TAKEN, SEVERE INJURY TO
PERSONNEL COULD RESULT.
A compression spring is packed in with the HST 3-Inch Upper Taping Head for use if the head is to be side
mounted. Remove and retain stop block, bumper and fasteners. Remove applying roller assembly. Place
compression spring on shaft and reassemble applying roller assembly and stop block.
Figure 3-1 – Compression Spring Installation
9