LOM adapter replacement
Use this information to remove and install the LOM adapter.
Remove the LOM adapter
Use this information to remove the LOM adapter.
Chapter 4 "Read
the
installation
Guidelines" on
page 29
Before removing the LOM adapter:
1. Remove the top cover.
2. If riser 1 assembly is installed, remove it to access the LOM adapter slot.
To remove the LOM adapter, complete the following steps:
Figure 46. LOM adapter removal
Step 1.
Loosen the thumbscrew that secures the LOM adapter.
Step 2.
Push the LOM adapter out of the connector on the system board.
Step 3.
Slide the LOM adapter as shown and lift the LOM adapter out of the chassis.
If you are instructed to return the old LOM adapter, follow all packaging instructions and use any packaging
materials that are provided.
Install the LOM adapter
Use this information to install the LOM adapter.
"Power off
the server
for this task"
on page 34
Chapter 5
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 31
.
Hardware replacement procedures
69