Replacing Oven Lights - Viking Range VGR736 Use & Care Manual

Cleaning and Maintenance
Control Panel
DO NOT use any cleaners containing ammonia or abrasives. They could remove
the graphics from the control panel. Use hot, soapy water and a soft clean cloth.
Control Knobs
MAKE SURE ALL THE CONTROL KNOBS POINT TO THE OFF POSITION BEFORE
REMOVING. Pull the knobs straight off. Wash in detergent and warm water. Dry
completely and replace by pushing firmly onto stem. DO NOT use any cleaners
containing ammonia or abrasives. They could remove the graphics from the knob.
Oven Surfaces
Several different finishes have been used in your oven.
NEVER USE AMMONIA, STEEL WOOL PADS OR ABRASIVE CLOTHS, CLEANSERS, OVEN CLEANERS, OR ABRASIVE
POWDERS. THEY CAN PERMANENTLY DAMAGE YOUR OVEN.
VDR models – Your oven features a self-clean cycle for the oven interior. See the "Self-Clean Cycle" section for complete
instructions.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot soapy water after they have cooled and with a liquid cleaner
designed for that material when soapy water will not do the job. DO NOT use steel wool, abrasive cloths, cleansers, or powders. If
necessary, scrape stainless steel to remove encrusted materials, soak the area with hot towels to loosen the material, then use a
wooden or nylon spatula or scraper. DO NOT use a metal knife, spatula, or any other metal tool to scrape stainless steel. DO NOT
permit citrus or tomato juice to remain on stainless steel surface, as citric acid will permanently discolor
stainless steel. Wipe up any spills immediately.
Glass Surfaces
Clean with detergent and warm water. Glass cleaner can be used to remove fingerprints. If using glass cleaner ammonia, make
sure that it does not run down on exterior door surface.
Broiler Pan and Grid
Clean with detergent and hot water. For stubborn spots, use a soap-filled steel wool pad.
Oven Racks
Clean with detergent and hot water. Stubborn spots can be scoured with a soap-filled steel wool pad.

Replacing Oven Lights

WA RN I N G
ELECTRICAL SHOCK HAZARD
Disconnect the electric power at the main fuse
or circuit breaker before replacing bulb.
DO NOT touch bulb with bare hands. Clean off any signs of oil from the
bulb and handle with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto metal box.
5. Reconnect power at the main fuse or circuit breaker.
WARN IN G
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
30
1
1
2
3
4