Replacing Oven Lights; Troubleshooting - Viking Range Tuscany TVDR4806B Use And Care Manual

Replacing Oven Lights

The lights inside the oven are located in the top near the door opening.
To replace the light bulb:
1. Locate light bulb cover in top of oven cavity.
2. Unscrew glass light cover.
3. Use oven miitt during bulb removal to protect your hand in case the bulb breaks.
4. Replace the bulb with a 230 volt, 25-watt appliance bulb.
5. Replace the light cover
6. Reconnect power at the main fuse or circuit breaker.

Troubleshooting

Problem
Range will not function.
Broil does not work.
Oven light will not work.
Igniters will not work.
Igniters sparking but no fl ame ignition.
Igniters sparking continuously after
fl ame ignition.
Burner ignites but fl ame is large, distorted, or
yellow.
Strong odor and/or smoke is noticed fi rst few
times oven is used.
Oven indicator light on; oven will not heat.
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT touch a hot oven light bulb with a damp
cloth as the bulb could break. Should the bulb break,
disconnect electric power to the appliance at the
main fuse or circuit breaker before removing bulb to
avoid electrical shock.
Possible Cause and/or Remedy
Range is not connected to electrical power: Have electrician
check power circuit breaker, wiring, and fuses.
Temperature control knob is rotated too far past
broil position.
Light bulb is burned out.
Range is not connected to power.
Circuit is tripped.
Fuse is blown.
Range is not connected to power.
Gas supply valve is in "OFF" position.
Gas supply is interrupted.
Power supply is not grounded.
Power supply polarity is reversed.
Igniters are wet or dirty.
Burner ports are clogged.
Unit is being operated on wrong type of gas.
Air shutters not properly adjusted.
This is normal burn off of insulation and protective oils in oven.
This will go away after using oven a few times.
Oven is operating properly. Unit will resume heating
function once it has cooled.
22