Pusher Spring Replacement - U-Line H-1024 Instruction Manual

4. Remove the linkage mechanism and adjusting rod
simultaneously from the body.
5. Loosen the pivot screws with flat screwdriver. Remove
handle and linkage mechanism.
Remove the spring pin with a hammer and 5 mm
straight rod.
6. Loosen screws with a 3 mm Allen wrench. Take off
the spring pin with a hammer and 6 mm straight rod.
(See Figure 16)
Figure 16

PUSHER SPRING REPLACEMENT

1. Loosen the screws and nut with 8 mm spanner
wrench and 4 mm Allen wrench. (See Figure 17)
Figure 17
2. Remove the magazine assembly. (See Figure 18)
Figure 18
PAGE 5 OF 18
OPERATION CONTINUED
3. Pull the pusher back until it stops on the rod, rotate
4. Push the magazine seat back and remove it from
5. Loosen the screw and nut with 2.5 mm Allen wrench
6. Loosen the rod with a 6 mm offset wrench and
7. Remove the spring pin with hammer and 4 mm
the pusher to position.
the magazine.
and 7 mm socket wrench. (See Figure 19)
Figure 19
remove the pusher guides. Remove the pusher.
(See Figure 20)
Figure 20
straight rod. (See Figure 21)
Figure 21
0323 IH-1024