Table of Contents
Advertisement
5 Operation
5.4 Voltage measurements
1.
Set the function switch to one of the following positions:
•
for high voltage measurements.
•
for low voltage measurements.
•
for voltage measurements using the meter's low input impedance
mode. The
2.
Insert the black probe lead into the negative
lead into the positive
3.
Use the
•
The
indicator will be displayed for AC measurements.
•
The
indicator will be displayed for DC measurements.
•
The
indicator will be displayed for AC+DC measurements.
4.
Connect the probe leads in parallel to the part under test.
5.
Read the voltage value on the display.
5.5 Resistance measurements
WARNING
Do not do diode, resistance, or continuity tests before you remove the power
from the capacitors and the other devices (when you do a test during a meas-
urement). Injury to persons can occur.
1.
Set the function switch to the
2.
Ensure that the meter is set to resistance measurement. The Ω unit will be
displayed.
If the
or
the Ω unit is displayed.
3.
Insert the black probe lead into the negative
lead into the positive
4.
Touch the tips of the probe across the circuit or component under test.
5.
Read the resistance value on the display.
#T559824; r. AN/86262/86262; en-US
indicator is displayed.
terminal.
button to select AC, DC, or AC+DC voltage measurement.
indicator is displayed, press the
terminal.
terminal and the red probe
position.
terminal and the red probe
button repeatedly until
16
Advertisement
Table of Contents
