5.3 Auto/Manual Range Mode
In Auto range mode, the meter automatically selects the most appropriate measurement scale. In
Manual range mode, the desired range (scale) is set manually.
Auto range mode is the default mode of operation. When a new function is selected with the
function switch, the starting mode is Auto range and the indicator is displayed.
To enter Manual range mode, press the
repeatedly until the desired range is displayed.
To enter Auto range mode, press and hold the
5.4 Voltage Measurements
1.
Set the function switch to one of the following positions:
for high voltage measurements.
for low voltage measurements.
2.
Insert the black probe lead into the negative COM terminal and the red probe lead into the
positive
terminal.
3.
Use the
The
The
The indicator will be displayed for AC + DC measurements.
4.
Connect the probe leads in parallel to the part under test.
5.
Read the voltage value on the display.
5.5 Resistance Measurements
Warning: Do not do diode, resistance or continuity tests before you have removed the power from
capacitors and other devices under test during a measurement. Injury to persons can occur.
1.
Set the function switch to the
2.
Ensure that the meter is set to resistance measurement. The Ω unit will be displayed.
If the or
displayed.
3.
Insert the black probe lead into the negative COM terminal and the red probe lead into the
positive
terminal.
4.
Touch the tips of the probe across the circuit or component under test.
5.
Read the resistance value on the display.
FLIR DM92 USER GUIDE Document Identifier: DM92‐en‐US_AB
for voltage measurements using the meter's low input impedance mode. The
indicator is displayed.
button to select AC, DC, or AC + DC voltage measurement.
indicator will be displayed for AC measurements.
indicator will be displayed for DC measurements.
position.
indictor is displayed, press the
button. To change the range, press the
button until the indicator is displayed.
button repeatedly until the Ω unit is
14
button