Active; Effect Circuits - Elektron Analog Heat +FX Quick Manual

Hide thumbs Also See for Analog Heat +FX:

Table of Contents

SAVING A PRESET

1. Press and hold the [FLOW] and [HEAT] keys simultaneously for two seconds to

open the preset list. The selected preset starts to blink to illustrate that you are

about to overwrite a preset position.

2. Press a DATA ENTRY knob to select bank A–D if you want to save the preset to

different bank.

3. Turn NAVIGATION to select the preset slot to where you want to save your

sound and then press [YES].

4. (Optional) Turn NAVIGATION to the character you wish to edit. Press and hold

[SETTINGS] and then turn NAVIGATION to move the cursor to the desired char-

acter and select it by releasing [SETTINGS]. To delete a character, turn NAVI-

GATION to move the cursor to highlight the character after the one you wish to

delete, then press and hold [SETTINGS] and press [NO] twice.

5. Press [YES] to save the preset.

5.2 ACTIVE

When you set the Active to ON, the Analog Heat +FX affects the incoming signal. The

active mode is toggled on and off by pressing [ACTIVE]. A lit [ACTIVE] key indicates that

the device is active. You can also use a footswitch to toggle the active mode. You also

have the option to set if you want the Analog Heat +FX to start as active or not when you

turn it on

You can use the CIRCUIT SELECTOR to choose between 8 different types of effect cir-

cuits in the Heat block for a wide variety of drive and distortion sounds.

CLEAN BOOST

•

Makes the signal louder. When fully driven, it sounds similar to overdriving old mixers.

Use for minimal distortion or when you only want to use the filter and EQ.

SATURATION

•

This circuit is reminiscent of classic tape saturation. Woolly and warm.

Table of Contents