Active - Elektron analog drive User Manual

LOADING A PRESET
Method 1
1. Turn PRESET to select the desired preset. The display blinks to indicate that the preset is not yet
loaded.
2. Press PRESET to load the selected preset.
Method 2
1. Press [FOOTSWITCH LEFT] (decrease) or [FOOTSWITCH RIGHT] (increase) to select the desired
preset. The slot decrement/increment can be done in steps of 10 by holding down either footswitch.
The display blinks to indicate that the preset is not yet loaded.
2. Press [FOOTSWITCH BYPASS/SELECT] to load preset.
N.B. If you wait for more than 30 seconds to load the new preset, the display stops blinking and
returns to the active preset's number.
SAVING A PRESET
1. Press and hold PRESET for 2 seconds. The display first shows SA and then blinks to indicate that
the preset is not yet saved.
2. Turn PRESET and select the preset slot to where you want to save the current sound settings.
3. Press PRESET to save.
N.B. If you wait for more than 5 seconds to save the preset, the display stops blinking and returns to
the active preset's number.
PRESET INDICATORS
When a preset is selected, the recalled values of the parameters might not be the same as the knobs
current physical position. As soon as a knob is turned, one of the <PRESET INDICATOR> LEDs indi-
cates which way the knob should be turned to locate the position corresponding to the value set in the
preset. When the knob is in the position that matches the stored value, both LEDs are lit for a short
while and then turn off.
N.B. Turning a knob does not change the parameter value until the knob position matches the
preset's stored value.

5.2 ACTIVE

The Analog Drive must be active to affect the incoming sound. If the pedal is not active, then the effect
is bypassed. Press [FOOTSWITCH BYPASS/SELECT] to toggle active on and off. The <ACTIVE> LED
indicates if the effect is active or not.
12