Download Print this page

Pre-Commissioning - Kärcher WRS 200 Manual

Hide thumbs Also See for WRS 200:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 19
Hydraulic hoses
1
Water connection
2
Cable with plug
3
2. Connect the hydraulic hoses to the WRS 200 and insert
them into the PTO hydraulic connection of the vehicle
(observe the correct flow direction and, if applicable, the
colour encoding).
3. Connect up the water hose.
4. Insert the cable with plug into the trailer socket.
Screw (retainer)
1
WRS 200
2
5. Slowly move the WRS 200 forwards as far as it will go
and then lower it into the adapter coupling triangle.
6. Secure the WRS 200 with the screw. Torque 80 Nm.
Figure: Upper link fastener for platform C
Upper link adjusting nut
1
Lock nut
2
Retaining pin with retaining clip (platform C)
3
26
7. Attach the left-hand and right-hand upper links to the ve-
hicle.
a Platform C: Attach using the existing retaining pins on
the vehicle and secure with the clips (see illustration).
b Platform D and E: Attach to the vehicle using screw,
washers and nuts (included in scope of delivery) (see
illustration).
Figure: Upper link fastener for platform D and E
Upper link adjusting nut
1
Lock nut
2
Screw with washer and nut (platform D and E)
3
8. Adjust the position of the WRS 200 using the adjusting
nuts and secure with the counter-nuts.
12

Pre-commissioning

WARNING
Risk of injury
Check that the battery, accessories, supply lines, water fil-
ter and connections are in a correct condition before using
the device.
Only use the device when it is in a correct condition.
1. Check the filling level in the fuel canister and fill if nec-
essary.
2. Check the filling level in the system care container and
fill with RM 110 if necessary.
3. Check the filling level in the water tank and fill if neces-
sary.
4. A licence plate (repeater licence plate) must be attached
before use on public roads. The license plate must be
attached centrally with a 40 mm clearance, parallel to
the tail lights.
12.1 Refuelling
DANGER
Explosion hazard due to overflowing fuel
Take care ensure that no fuel spills onto hot surfaces when
refuelling.
DANGER
Explosion hazard due to smoking and naked flames
Ensure strict prohibition of smoking and open flames dur-
ing the refuelling procedure.
WARNING
Health risk from inhaled vapours
Do not refuel in confined spaces.
ATTENTION
Risk of damage due to incorrect fuel
Refuel with Diesel only.
English

Advertisement

loading

This manual is also suitable for:

2.200-000.0