Attaching The Top Mount; Upper Link Position; Installing And Connecting The Wrs 200 - Kärcher WRS 200 Manual

9

Attaching the top mount

The top mount stabilises the WRS 200 during operation
and transport. It must be attached to the WRS 200 once
only.
For the MIC 35/42 (platform C) and the MC 250 (platform
E), mounting is performed below the air holes.
For the MC 130 or MIC 50/70 (platform D), mounting is per-
formed above the air holes. The following description
shows the mounting for platform D.
The holes for attaching the mount are already present.
Unless specified otherwise, all nuts and screws are to be
tightened to the standard torque.
Mounting to the carrier vehicle is made via 2 upper links.
Mounting is described in a later chapter.
Top mount attachments
Reinforcement plate (2x)
1
Right-hand holder
2
Left-hand holder
3
Upper links (2x)
4
Note
For mounting to the carrier vehicle
Screws M16x120 (2x)
5
Screws M16x100 (2x)
6
M16 stop nuts (4x)
7
18x200 washers (8x)
8
Mount fastening material
9
M8x30 screws (8x)
–
M8 nuts (8x)
–
8x200 washers (14x)
–
16x200 washers (8x)
10
Screw, washer, nut
11
For mounting the upper link on platform D
–
1. Check the scope of delivery.
Mount attachment for platform D (MC 130, MIC 50/70)
1
Mount attachment for platform C (MIC 35/42) and plat-
2
form E (MC 250)
Reinforcement plate
3
Outer screw
4
Note
Install this screw without a washer
Upper mount cutout
5
2. Attach the reinforcement plate with mount on the WRS
200 (observe the correct mounting procedure according
to the platform).
3. Use screws with washers and nuts.
At the mount side: Fit the outer screw without a washer.
4. Attach the right-hand mount in the same manner.
10

Upper link position

The upper link must be attached differently for platform C,
platform D or platform E.
Position for platform D
1
Position for platform C and E
2
Screw
3
Stop nut
4
Upper link
5
1. Attach the upper link in the corresponding position using
a screw and stop nut.
11

Installing and connecting the WRS 200

The WRS 200 is attached to the adapter with coupling tri-
angle and secured by a screw.
It is additionally fastened to the vehicle by the upper links.
Have a second person help with the installation.
WRS 200
1
Lift truck
2
Adapter with coupling triangle
3
1. Use the lift truck to position the WRS 200 approximately
30 cm in front of the adapter and then lift it until it is po-
sitioned above the adapter.
English 25