Table of Contents
Advertisement
Available languages
Available languages
Fasep 2000 srl
Balatron B433: User's Manual
2
INSTALLATION
2.1
Moving the unit
WARNING
2.2
Assembling the unit
For ease of transportation, the wheel balancer might be disassembled
into units. If necessary, assembling instruction are provided within
each package.
2.3
Installation
The wheel balancer must be installed on a firm and level ground.
NOTE:
the machine must be secured to the floor. Using four
holes in the base and anchor bolts provided.
2.4
Electrical Hookup
!
CAUTION:
2.4.1
Electrical hookup is to be provided by a qualified electrician.
2.4.2
A fusible wall-mounted switchbox is required at the installation site.
This switch should provide on-off control and overload protection
for your wheel balancer only. The switchbox should be fused with
time-delay fuse(s) in accordance with the power rating specified on
your wheel balancer.
2.4.3
Electrical connection of the machine should be by plug connectors.
2.4.4
The balancer must be effectively connected to ground. The electric cord is regularly provided with a ground terminal.
2.4.5
Make sure that Power Rate Specifications for your wheel balancer (refer to nameplate on the wheel balancer) comply with
those provided by the external power source.
!
CAUTION
When the unit has to be moved: never lift
balancer by motor shaft or by neighborhood of it.
Failure to follow these instructions can results
in damage to unit or create an electrical
hazard and will void warranty.
After electrical hookup has been performed unit is ready to operate. Always observe pertinent safety
precautions when operating the unit (see Appendix tables for an overview of relevant Safety
requirement).
2-1
Rev. 1.4
July 20, 2017
Advertisement
Chapters
Table of Contents
