Related Manuals for Joerns ProCair Plus
Summary of Contents for Joerns ProCair Plus
- Page 1 User-Service Manual Joerns Therapeutic Support Surfaces ® ProCair® Plus To avoid injury, read user’s manual before using.
-
Page 2: Important Precautions
• Do not place or store the product where it can fall or Joerns Healthcare if anything in this manual is unclear. be pulled into a tub or sink. Joerns will not be held responsible for any injuries •... - Page 3 Matching the right bed components in order to meet regulatory guidelines can be complex. Bed System Entrapment Information That is why Joerns offers a wide array of compliance In April 1999, the U.S. Food and Drug Administration options. We assist customers in selecting compliant (FDA) in partnership with representatives from the accessories recommended for their specific bed model.
-
Page 4: Table Of Contents
P.R.O. Technology PMP Control Unit CBC Control Unit Transport Power Failure Mattress Connection ..........10 Troubleshooting .............10 ProCair Plus surface is not alternating or increasing in pressure: Nursing Procedures ..........10 Recommended Linen: Patient Positioning and Comfort Contractures Incontinence Safety Information ..........11... -
Page 5: Introduction
Stage I and Maximum pressure redistribution is achieved through II pressure ulcers. The ProCair Plus may also be delivering a specific amount of air to each therapy cell. indicated for additional therapeutic intervention based This distributes the patient’s weight evenly over a wide... -
Page 6: Pain Management
ProCair Plus as an adjunct to pain management • Internal fully enclosed fire barrier meets interventions. BFD IX-11, 16CFR Part1633 and the expired... -
Page 7: Cbc Therapy Control Unit Features
Figure 1 ©2023 Joerns Healthcare • 6110053 RevD • 000478... -
Page 8: Powered Modes
This mode should be used along with the tightly connected without air leakage. Comfort Adjust buttons to increase or decrease the general firmness of the ProCair Plus mattress. • Alternate: The Alternate light is illuminated when in the Alternate mode. The pressure automatically alternates between adjacent cells. -
Page 9: Cbc Control Unit
Power light is illuminated. Power Failure Mode Selection In case of an extended power failure, the ProCair Plus The Mode switch is used to place the control unit in mattress system should be disconnected from the either the Powered Static or Alternating modes. -
Page 10: Mattress Connection
ProCair Plus mattress and the control unit ® Special linens are not necessary for the ProCair Plus, should be stored (see “Storage and Care” section). and there is no need for a bottom sheet. The mattress cover should be covering the therapy cells at all times. -
Page 11: Contractures
3. Thoroughly wipe down entire mattress 4. Remove gloves and dispose; wash hands Warning: Unplug the control unit from its power source. Failure to do so could result in personal injury or equipment damage. ©2023 Joerns Healthcare • 6110053 RevD • 000478... -
Page 12: Filter Cleaning
Remove the filter by grasping the filter and pulling Note: Clean the ProCair Plus as described in the outward. Replace with the second supplied filter. previous section prior to storage. -
Page 13: Fuse Replacement
11.18" (28.4 cm) W x 5.6" (14.2 cm) H x 3.5" (9 cm) D Electrical Specifications PMP Control Unit AC 100-240V 50/60 Hz 0.2-0.1A CBC Control Unit 120V AC, 60 Hz, 1A ©2023 Joerns Healthcare • 6110053 RevD • 000478... -
Page 14: Warranty
Joerns Healthcare personnel Any modification, repair or alteration done to the to determine if the claim is billable, or a non-charge ProCair Plus that were not authorized in writing by warranty replacement. Joerns Healthcare will void this warranty.
Need help?
Do you have a question about the ProCair Plus and is the answer not in the manual?
Questions and answers