Table of Contents
Advertisement
Joerns® Therapeutic Support Surfaces
ProCair® Plus
Pain Management
• AIDS
• Arthritis
• Oncology
The ProCair
Plus provides uniform distribution of
®
weight over a wide surface area, which relieves
pressure against bony prominences and provides
a soft, gentle therapy surface on which to lie. For
patients experiencing severe pain and discomfort due
to pressure and/or positioning limitations, consider
the ProCair Plus as an adjunct to pain management
interventions.
Note: The above are conditions and diagnoses
for which the ProCair Plus may be indicated.
Occasionally, there are orthopedic and neurological
patients that require body positioning to be maintained
in specific alignment. The ProCair Plus has safety
features and an inner therapy core to prevent deflation
of the therapy cells and to keep your patients in
flotation at all times. However, in the event of a
puncture or malfunction, the therapy cells may deflate
and not provide the necessary alignment. The use
of the ProCair Plus for these patients should be
considered on an individual basis and discussed with
the attending physician.
Features
Mattress Features
• Three-zone (shoulder, torso and foot) dynamic
pressure redistribution profile with 15 cell internal
design automatically adjusts to each patient's body
profile and weight
• The shoulder, torso and foot zones are optimized
independently to maximize pressure redistribution
• Dynamic, non-powered mattress easily converts
to powered alternating and static modes with
connected control unit (P.R.O. Technology PMP or
CBC)
• Automatic re-inflation of air zones through P.R.O.
Technology after patient removal - no adjustment or
manual inflation required
• Viscoelastic one-inch foam topper provides
maximum pressure redistribution, patient support
and increased comfort
• Integrated foot zone helps to protect delicate heel
area
• The surrounding firm perimeter provide stability
during patient care and transfer and helps support
patient safety
*Mattress weight capacity only; total weight must not exceed bed frame
manufacturers' specified load capacity.
6
©2023 Joerns Healthcare • 6110053 RevD • 000478
• Five inch deep internal cells are constructed of
highly durable therapy cells, specially designed for
automatic re-inflation without the use of a powered
system
• 360° zippered, two-way stretch, therapy cover
is constructed of a breathable, non-plasticizing/
moisture proof nylon, aiding in the prevention of
friction and shearing
• Scratch resistant rubber backing
• Internal non-kinking hose sets
• Top cover is fluid, stain and odor resistant and is
treated with a highly effective bacteriostatic agent to
inhibit the growth of bacteria and fungus
• Internal fully enclosed fire barrier meets
BFD IX-11, 16CFR Part1633 and the expired
CA TB603 flammability standards
• Supports patients weighing up to 500 lbs.*
P.R.O. Technology
PMP Control Unit
®
Features
• Two therapy modes of operation – Alternating and
Powered (static)
• Alternating mode alternates the air pressure in
adjacent cells throughout the mattress (excluding the
head section)
• Four alternating pressure cycle times: 5, 10, 15 and
20 minutes
• Autofirm setting of unit provides maximum air
inflation designed to assist both patients and
caregivers during patient care and transport
• Five comfort control settings to maximize patient
compliance and promote healing.
• Compact lightweight control unit is quiet and energy
efficient
• Crisp, easy to read graphics for intuitive set up and
therapy control
• Closed loop pressure sensor control system
eliminates concerns of changes in mattress interface
pressure due to ambient temperature and pressure
changes
• Integrated swing out hanging brackets for fixing to
most bed types
• Quick disconnect hoses allow for rapid attachment at
the mattress (removable at the control unit)
Three-Zone
System
3
Foot
1
Shoulder
2
Torso
Advertisement
Table of Contents
