Table of Contents
Advertisement
Introduction
The ProCair
Plus, provided by Joerns Healthcare, is
®
a convertible dynamic pressure redistribution mattress
replacement system. Pressure redistribution and
alternating pressure therapy have been demonstrated
to reduce the risk of pressure ulcers and as being a
valuable aid in the treatment of pressure ulcers.
Warning: The risk of entrapment can arise when
equipment is placed on bed frames that leave gaps of
even a few inches between the mattress and the head
panel, foot panel, and bed or side rails. The equipment
is NOT to be used when such gaps are present. See
"Important Precautions" section of this manual.
The ProCair Plus replacement system is suitable
for at-risk patients and treatment for Stage I and
II pressure ulcers. The ProCair Plus may also be
indicated for additional therapeutic intervention based
on patient's specific assessment.
With the addition of an optional control unit, the
therapy can take three forms:
• Alternating– where the mattress therapy cells
alternate in pressure.
• Powered– where the mattress internal pressures are
increased
• Autofirm– provides maximum air inflation that
may be used to assist during some patient care
procedures or to aid in patient transfer
Pressure Redistribution Optimization (P.R.O.)
Technology is a unique, patent pending, air control
technology. The P.R.O. Technology
no adjustments or manual inflation devices and
features a three-zone inner air core that automatically
adjusts to meet the needs of each patient based on
body profile and weight. The head zone remains static
and is comprised of high density foam for maximum
patient comfort while the shoulder, torso and foot
zones are optimized independently to maximize
pressure redistribution.
We have ensured that the ProCair Plus addresses key
areas in the treatment of compromised skin: pressure
redistribution and reduction in both friction and
shearing forces.
system requires
®
Joerns® Therapeutic Support Surfaces
Pressure Redistribution
ProCair Plus is a convertible dynamic pressure
redistribution mattress system that has three modes
of operation: non-powered, alternating pressure and
static. The alternating and static modes require the
use of an optional control unit (P.R.O. Technology PMP
or CBC). The non-powered mode requires only that
a control unit not be attached and that any external
hoses are disconnected from the mattress. In the
non-powered mode ProCair Plus functions as dynamic
pressure redistribution mattress.
The alternating mode increases circulation to
the patient while providing maximum pressure
redistribution by alternating pressure between adjacent
therapy cells throughout the length of the mattress.
Maximum pressure redistribution is achieved through
delivering a specific amount of air to each therapy cell.
This distributes the patient's weight evenly over a wide
surface area resulting in average pressure readings
well below capillary closure levels.
Shear and Friction Reduction
Shearing occurs when the skin is stationary in relation
to the support surface, while the underlying tissues
and vessels are stretched and damaged. When
a patient's skin rubs against another surface, the
result is friction. The ProCair Plus therapy cover is
constructed of a breathable, non-plasticizing/moisture
proof nylon with a scratch resistant rubber backing
with low friction and shear properties to protect the
patient's skin from these damaging forces.
Indications for Use
Pressure Redistribution
• Pressure Ulcers
• Rehabilitation
• Neurology
• Dermatology
• Burns
• Amputations
The selection of a pressure redistribution surface
needs to be based on each individual patient's clinical
condition or diagnosis and co-morbidities. The ProCair
Plus provides average pressure readings well below
capillary closure levels (32mm of Mercury) and allows
for adequate perfusion to promote healing.
ProCair® Plus
©2023 Joerns Healthcare • 6110053 RevD • 000478
5
Advertisement
Table of Contents
