Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co., Ltd.
Node type 03; Network status 02; Network short address FE 5B; Local network short address F6 FA; Local MAC address 1F 1C 21
FE FF 57 B4 14; Parent node network short address 00 00; Parent node MAC address 0C 46 0C FE FF 9F FD 90; network group
number 01; channel 0B; sending power 0A; baud rate 09; sleep time 54; target network short address 00 00; target network group
number 00; ; System sending mode 02; Data output mode 00; Network opening time FF (the coordinator is valid and this module does
not support); rejoin cycle 05; rejoin times 05; wireless ID A8 8A;
6.6.24 Configure AUX to wake up external MCU serial port delay printing time
in wireless receiving state
Read instruction format:
command format
send： FE 01 35 FF
return： FB 35 AUX_delaytime
Configuration command format：
command format
send：FD 01 35 AUX_delaytime FF
return：FA 35
AUX_delaytime: 1~255, the unit is ms, the default parameter is 4ms, that is, after the module receives the wireless data, it first pulls
down the AUX pin to wake up the external MCU, and then delays 4ms to output the serial port data to the external MCU.
6.6.25 Configure serial port wake-up hold time
Read instruction format:
command format
send： FE 01 36 FF
return： FB 36 Uart_holdtime
Configuration command format：
command format
send：FD 01 36 Uart_holdtime FF
return：FA 36
Uart_holdtime: 1 ~ 255, the unit is 10ms, the default parameter is 100, that is, the serial port will keep waking up for 100*10ms after
waking up, and then go to sleep after 1000ms.
6.6.26 Configure endpoint information
Read instruction format:
command format
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co., Ltd.
command example
send： FE 01 35 FF
return： FB 35 04
command example
send：FD 01 35 04 FF
return：FA 35
command example
send： FE 01 36 FF
return： FB 36 64
command example
send：FD 01 36 64 FF
return：FA 36
command example
E180-Z5812SP Product Manual
31
Advertisement
Table of Contents
