Chapter 6 Application Function And Command Configuration; Function Pins; Detailed Explanation Of Link; Detailed Explanation Of Wake - Ebyte E180-Z5812SP Product Manual

Zigbee multifunctional soc wireless module

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd.

E180-Z5812SP Product Manual

Note: The terminal device can resolve the long address of the sending device such as the coordinator, router and terminal, but the

coordinator and router cannot resolve the long address of the terminal sending device

The coordinator and router here are E180-Z8910SX/P products.

Note: The sender supports a single packet with a maximum packet length of 72 bytes

Chapter 6 Application Function and Command Configuration

The LINK pin indicates the current network status of the module. After the device is successfully connected to the network, the current

pin is pulled high. When the device has no network or the parent node is lost, this pin is pulled low. External devices can query the

network status of the device through the pin level.

The WAKE pin is mainly used to wake up the dormant terminal. It defaults to a high level when powered on. When the pin is pulled

low externally, the dormant terminal device will continue to be woken up. When the pin is released externally, it returns to a high level

and enters dormancy. ;The sleep time is determined by the duration of the external pull down of this pin; for non-sleep devices, this pin

is meaningless;

The AUX pin indicates the current working status of the device. When the pin is low, it indicates that the device is busy; when the pin

is high, it indicates that the device is idle; when the device receives data, the module pulls the AUX pin low and after the

AUX_delaytime time, the serial port starts to output Data, used to wake up external control devices, AUX_delaytime defaults to 4ms,

can be changed by serial port instructions, and the customer decides according to the wake-up time of the main chip;

The ACK pin is used to indicate the status of the last user data transmission. The pin is pulled low before the transmission is started,

and the pin is pulled high after the transmission is successful. The user can judge whether the data has arrived successfully through the

state of the pin. This pin function cannot instruct the coordinator to send a broadcast message. (Only works on non-sleeping terminals).

Table of Contents

Tlsr8258