Ebyte E180-Z5812SP Product Manual page 15

Chengdu Ebyte Electronic Technology Co., Ltd.
network address
Local MAC
address
Destination
MAC address
Equipment type
Channel
Sending mode
Output mode
Transmit power
Remote Config
ID
Local network
group number
Target network
group number
Wakeup period
(sleep time)
Lost parent
node
reconnection
period
Copyright ©2012–2019, Chengdu Ebyte Electronic Technology Co., Ltd.
0xFFFF
Read 64bitMAC
Read/Write 64bitMAC
Read/Write E、S
Read/Write CH11～26
Read/Write 0、1、2、3、
4、5
Read/Write 0、1、2、3、
4、5
Read/Write 0dbm～
12dbm
Read/Write 2 Bytes
Read/Write 1～254
Read/Write 1～254
Read/Write 0～2010 S
Read/Write 1～254
minutes
can be switched at any time through configuration
commands;
The MAC address assigned by the network of this
module cannot be changed by the user (re-entry network
change)
In fixed-point mode, use long address to send
They are: non-dormant terminal, dormant terminal;
The physical channel of ZIGBEE work;
Configure the transmission mode of the module, which
are: broadcast mode, multicast mode, short address
on-demand mode, long address on-demand mode,
protocol on-demand, protocol multicast, please refer to
the corresponding mode function introduction for
details;
Configure the data output mode of the module,
respectively:
Penetrate;
Data + short address;
data + long address;
data+RSSI;
Data + short address + RSSI;
Data + long address + RSSI；
The output power of the module has high requirements
on power consumption, and the transmission power can
be reduced to save average power consumption in
occasions where there is no requirement for distance;
It is used to judge whether the data received wirelessly
in the air is a remote configuration command.
Customers can change the unlimited configuration ID
according to their needs. The default is A8 8A;
Used to configure the group number of the device in the
network;
It is used to configure the group number of the
corresponding target when the device is multicasting;
It is used to configure the wake-up cycle of the terminal
sleep device. The larger the cycle, the lower the overall
power consumption, but the greater the delay in
receiving data;
When the parent node is lost (the coordinator is powered
off), the terminal device reconnects to the previous
network at regular intervals;
E180-Z5812SP Product Manual
14