Unisys Aquanta CP Series Configuration Manual page 53

Table 3–1. Troubleshooting Guide (cont.)
Problem
My workstation cannot see the
network.
My operating system does not
load from the hard disk.
The application software I just
installed does not run properly.
3814 9779–000
Solution
Make sure all network cables are properly connected and
the NIC jumper settings are correct.
Verify that the proper driver(s) is installed.
Make sure all power cables and drive cables are properly
connected, and that all system and drive jumpers are
correctly set.
Boot DOS or Windows 95 from a floppy disk and run fdisk.
Verify that the hard disk partition is intact.
If you are running Windows NT, boot from the three floppy
startup disks, and select Repair when prompted. You will
need the NT system files, either on floppy or CD, to make
the repair.
Make sure your software and system are correctly
configured. For information on software configuration, see
the manuals that came with your application.
Make sure you are using an authorized copy of the
application software.
Make sure that your system unit has enough memory and
disk space to run the program.
Check the keyboard and system board jumper settings to
make sure they are correct.
Verify that the video driver and drive type are correct.
Troubleshooting
3–13