Upgrading Your 3.5-Inch Hard Drive - Unisys Aquanta CP Series Configuration Manual

Upgrading Your 3.5-Inch Hard Drive

1. Turn the system off. Disconnect the power cord and all peripherals.
2. Remove the system unit cover, as described earlier in this section.
3. Remove the front panel, as described earlier in this section.
4. Remove the four screws that secure the old hard drive to the drive bracket, and
slide the old hard drive out of the bracket.
5. Open the drive carton, and remove the new drive.
6. Insert the new drive into the drive bracket, and attach the drive to the bracket with
four screws, as shown in Figure 1–9.
7. Replace the front panel, as described earlier in this section.
8. Replace the system unit cover, as described earlier in this section.
9. Reconnect the power cord and all peripherals, then turn the system on.
10. Run the BIOS Setup utility, and verify the success of your installation. Refer to
Section 2 for details.
3814 9779-000
Upgrading Your System
1–21